Search the Community

Dear Fellow Modellers, Finally I'm starting my thread on this much anticipated GB. I'm building Revell's 1/72 A-4 version and will be using Quickboost's resin exhausts and Eduard's BIGED PE and mask set. I'll be building scheme A, as shown in the box, for an aircraft based in Sicily, Italy, June 1941: As usual, here are pictures of the sprues. The clear parts are good, very transparent, without defects: The plastic is beautifully detailed, neither too soft nor too hard: This is the decal sheet, which looks good: I'll have to use swastikas from an xtradecal sheet. There's a total of 125 parts. But I just can't build anything out of the box, so here are the resin exhausts: The following are the several PE sets that come in the BIGED set. The interior PE parts (2 frets): The exterior PE set: The surface panels set: And the canopy masks, which are a must for these German bombers: Building starts with the cockpit. This is the first part: The moulded detail was removed, to be latter replaced by PE: The second part: The levers on the left hand side were also removed, as they will be replaced by metal levers: The two parts were glued together. Fit is very good: These two parts, complete the cockpit base. The level of detail out of the box is superb: The cockpit base was assembled: The control column was also removed from the sprue: It will be glued in place after painting. Now starts the PE odyssey. First, I assembled the levers. This metal part, already bent, will hold one of them: Here are the levers, ready for installation: The levers were glued in place of the plastic ones that had been removed: The next step is building the pedals, their mechanisms and supporting beams: However, all plastic in this step will be replaced by PE, as shown in the PE instructions: I started with the supporting beams. Here we can see one ready and the other just removed from the fret: The same here for the mechanisms: These parts were glued together: For comparison, here are the replaced plastic parts: The enhanced level of detail provided by the PE parts is readily apparent. Here we can see the pedals: one ready, the other just out of the fret: For comparison, here is a plastic pedal and a PE pedal, side by side: I think the increased effort of preparing and assembling the PE parts is fully compensated by the enhanced realism achieved. Moving on to the cockpit walls, here is the port wall: Some detail was removed, to be latter replaced by pre-painted PE, and the unpainted PE detail was glued in place: The starboard side wall. The moulded detail is superb: but some must be removed: I'll post more progress tomorrow, as this post is quite big already. Thanks for looking. Cheers Jaime